MKX16 X-Tend: service the hopper drive chain
Identify the correct chain before adjusting; different hopper drives have different settings.
Manual-linked job
AGI · Guide
STX auger: investigate repeated shear-bolt failure
Find the overload or worn coupling before replacing another protective bolt.
- Resource type
- Guide
- Equipment
- Portable augers & spouts
- Access
- Workshop membership
Confirm model, serial/PIN range, region and installed components. External documents and media are provided by their publishers; Knopp Management is independent of these manufacturers.
Related resources
STX auger: motor runs but flighting does not turn
Trace where motion is lost without opening guards on running machinery.
Manual-linked job
STX auger: replace, align and tension drive belts
Replace the correct matched belts and check pulley alignment before restarting.
Manual-linked job
WCX 1335: correct a slipping conveyor belt
Check belt condition, adjust both sides evenly and verify tracking after tensioning.
Manual-linked job
WCX 1335: correct off-center belt tracking
Separate a moving belt edge from persistent misalignment and adjust with power isolated.
Manual-linked job
WCX 1335: find why grain leaks at the hopper
Distinguish flashing wear, a damaged hopper and a tracking fault before replacing parts.
Manual-linked job