MKX16 X-Tend: service the hopper drive chain
Identify the correct chain before adjusting; different hopper drives have different settings.
Manual-linked job
AGI · Manual
MK130 Reversing Kit Installation, Operation & Safety
Manufacturer installation and operation instructions. Searchable document with page references. R2 · Publication number/date not stated
- Resource type
- Manual
- Equipment
- Grain handling
- Length
- 5 PDF pages
- Language
- English
- Source checked
- 2026-09-20
- Access
- Document link free; text search with membership
Confirm model, serial/PIN range, region and installed components. External documents and media are provided by their publishers; Knopp Management is independent of these manufacturers.
Related resources
STX auger: investigate repeated shear-bolt failure
Find the overload or worn coupling before replacing another protective bolt.
Manual-linked job
STX auger: motor runs but flighting does not turn
Trace where motion is lost without opening guards on running machinery.
Manual-linked job
STX auger: replace, align and tension drive belts
Replace the correct matched belts and check pulley alignment before restarting.
Manual-linked job
WCX 1335: correct a slipping conveyor belt
Check belt condition, adjust both sides evenly and verify tracking after tensioning.
Manual-linked job
WCX 1335: correct off-center belt tracking
Separate a moving belt edge from persistent misalignment and adjust with power isolated.
Manual-linked job